After the bulb is extracted you need to use butt splice connectors to tightly connect both the standard and high beams together to a +12V and ground lead to be strung out the side of the projector. There will be three or four leads. Look through the glass to find which lead goes where, and activate both the regular and high beams at the same time. I used automotive connectors so I can change the bulb out if needed. To hook the PC power supply to the bulb connect a +12v lead (yellow) and a ground wire (black) to the automotive bulbs contacts.
You will need to crimp, solder or use wire nuts because your dealing with a good amount of power. To power the bulb you either need a big 8+ amp 12v supply or use an old PC power supply. If your using a PC supply you will need to manually activate it or hot wire it.
Here's a how to : http://www.techwarelabs.com/guides/misc_mod/psumod/
You will need to crimp, solder or use wire nuts because your dealing with a good amount of power. To power the bulb you either need a big 8+ amp 12v supply or use an old PC power supply. If your using a PC supply you will need to manually activate it or hot wire it.Here's a how to : http://www.techwarelabs.com/guides/misc_mod/psumod/
No comments:
Post a Comment